Roasted squash makes a delicious side dish for any meal.
With its slight kick, this chili-roasted squash might become your new favourite side dish.
1 Preheat the oven to 400°F. Slice the squash in half crosswise. Scoop out the seeds and pulp, discarding the pulp. Rinse the seeds and set aside to drain. Slice each squash half into 1/4"- to 1/2"-thick rounds.
2 In a large mixing bowl, combine 3 tablespoons of the olive oil, the maple syrup, cumin, chipotle chili powder, paprika and salt. Add the squash and toss to thoroughly coat.
3 Arrange the squash in a single layer on a large baking sheet, overlapping the slices slightly if necessary. On a separate baking sheet, toss the squash seeds with the remaining 1 teaspoon olive oil and a light sprinkle of salt.
4 Place the squash and seeds in the oven. Roast the squash, turning the slices halfway, until fork-tender, golden brown and caramelized, 20 to 25 minutes. Check on the seeds after 10 minutes and remove from the oven when golden brown.
5 Place the squash on a large serving dish. Sprinkle the toasted seeds, queso fresco and cilantro over the squash. This dish is best served warm.
Prep & cook time: 45 minutes
BUY THIS BOOK
Excerpted from Vibrant Food by Kimberley Hasselbrink. Copyright Kimberley Hasselbrink © 2014. Excerpted by permission of Ten Speed Press. All rights reserved.
Make this twist on traditional lasagne with this recipe from Elana Karp and Suzanne Dumaine's new cookbook Plated.
1 Preheat the oven to 425°F.
2 On a baking sheet, toss the mushrooms and squash with 2 tablespoons of the olive oil and salt and pepper.
3 Arrange in a single layer and roast until tender, about 18 minutes.
4 While the vegetables roast, strip the stems from the kale leaves, then cut the leaves into bite-sized pieces. Thinly slice the garlic. In a large pan, heat the remaining olive oil over medium heat until shimmering. Add the kale and garlic and cook until the kale is wilted and bright green, about 4 minutes. Season with salt and pepper; set aside.
5 Remove the roasted mushrooms and squash from the oven and reduce the oven temperature to 400°F. Using a fork or spoon, mash the squash.
6 To make the béchamel sauce, melt the butter in a saucepan over medium heat. When the butter is foamy, sprinkle in the flour and whisk until the mixture is smooth and golden, about 2 minutes. Slowly pour in the milk, whisking continuously, until no lumps remain. Simmer, stirring occasionally, until the sauce is thick and coats the back of a spoon, 6 to 7 minutes. Season with the nutmeg, salt and pepper. Add 1/4 cup of the Parmesan, stirring to combine; remove the pot from the heat.
7 Spread a thin layer of the béchamel sauce over the bottom of a 9" x 13" baking dish. Add a layer of the lasagna noodles, followed by a layer of squash and mushrooms, the kale, more sauce and a sprinkle of Parmesan. Repeat to make 2 more layers: noodles, vegetables, sauce and Parmesan. Top with a final layer of noodles and the remaining béchamel sauce. Sprinkle with the remaining Parmesan and the Gruyère.
8 Loosely cover the dish with foil, transfer to the oven and bake until the lasagna is bubbling, about 30 minutes.
9 Increase the oven temperature to 450°F.
10 Uncover the lasagna and continue baking until golden, about 10 minutes longer. Remove from the oven and allow to cool completely before cutting into pieces. Wrap with foil and store in the fridge for up to 5 days or in the freezer for up to 1 month. To reheat, microwave the lasagna or warm it, covered, in the oven at 350°F.
Excerpted from Plated by Elana Karp & Suzanne Dumaine. Recipes Copyright © 2016 Elana Karp & Suzanne Dumaine, Photography copyright © 2016 Robert Bredvad. Excerpted by permission of Clarkson Potter/Publishers. All rights reserved.
How to: Paint outdoor furniture
When undertaking a DIY project, there are usually a few things to consider. Add tempermental weather to the list and suddenly that little list has multiplied. How do you prepare your furniture for painting? What type of paint do you use? How does it differ for different types of material?
Though the process of painting outdoor furniture may seem daunting now, the best way to go about a DIY job is to be prepared. We talked to an expert at Canadian Tire to do just that. Michael Bache, Category Business Manager at Canadian Tire, shares his prepping and painting how tos to help put your DIY nerves at ease.
1 What supplies will you need for prepping and painting?
Depending on the state of the furniture (e.g. new wood, old plastic, painted metal, painted wood) and the type of paint chosen, a variety of items should be considered.
If using brush-on paint, consider using a primer before applying a new fresh coat of colour. When priming your furniture, make sure to use a good quality paintbrush and rags or drop cloths for clean-up. However, if you're using Krylon® Fusion™ no primer is required.
If repainting a metal or wood surface that has loose peeling paint, it must be removed for best adhesion. You can use sandpaper, steel wool, wire brush, scraper, or a stripper. You may require a tack cloth to clean up dust residue when sanding. If sanding a latex paint, a simple damp rag will work just fine.
2 Do these steps differ when prepping different materials, such as metal, plastic, wicker or wood?
Yes. Some products don't require primer, saving you a prep step. Using an aerosol is a benefit, too, as you also save a step in the prep. It generally dries faster and doesn't require clean-up since no paint brushes are involved. Even better, aerosols tend to give a factory style, air brush finish when applied properly, as opposed to a brush-on paint.
Bare wood generally requires a primer to seal the wood prior to painting as the surface is porous. The primer is used to provide a nice, smooth finish. Krylon Dual saves a step on both bare wood and metal since it primes and paints in one easy step. This saves time and allows people to have more time enjoying their furniture and less time prepping it!
3 What type of paint should you use for outdoor furniture?
Always follow the directions on the label for specific product use. This will ensure proper adhesion to your surface.
Plastic patio furniture should only have a paint specifically designed to adhere to plastic and hard-to-bond surfaces. Many general purpose paints can adhere to most surfaces except plastic.
For wicker or rattan, spray paints tend to make a nicer finish and easily gets into the grooves. Muskoka chairs are also easier to paint when using an aerosol as opposed to a paint brush. Now there's even an aerosol wood stain by Krylon. Spray stains make fast work of Muskoka chairs and planters - no brushes to clean up either.
5 What about rust prevention?
Paint designed especially for metal surfaces tends to add rust protection into the paint - make sure the paint says "rust proofing" or "rust inhibiting".
As our climate changes, U.V. rays are also a consideration - they're hard on our skin and our exterior patio furniture! Some paints actually have U.V. protection in their paint. This will help protect your finish to resist harsh weather conditions. We suggest storing patio furniture during the fall and winter months when not in use. If space is a problem, a variety of covers and tarps are available to help protect your investment.
6 What are the best painting methods to use?
Much of this is personal preference. However, some surfaces, like wicker and rattan, have a nicer finish when sprayed versus brushing.
7 What kind of finish, if any, should you use?
Most paint companies offer a variety of finishes to choose from - satin, gloss, textured, metallic, hammered, and more. As long as you use an appropriate paint for your exterior surface and follow the instructions, you should achieve the finish you want. The really nice thing about the variety of paints and finishes available is that people can turn "garage sale finds" into treasures. Mixing and matching old and new creates a different and personalized patio set.
8 How many coats should you use
Follow the instructions on the can, however many paints suggest two coats. When painting remember this rule of thumb: Thinner coats are better than thicker coats. Thinner coats dry faster and produce a harder finish.
9 What should you look for in a brush?
Is it the right paint brush for your paint? Oil-based paints generally have different bristles than latex paints. The brush label will specify this.
Is the paint brush the right size to do your project? If you are painting furniture, smaller brushes may be better. Ensure it fits into your paint container.
A roller can be great for large flat surfaces, like a tabletop. This can help reduce brush marks, too!
10 How does climate affect the painting process?
Weather is a big factor. For the most part, if you're getting a sunburn and sweating, it's probably too hot to paint. This will cause the paint to dry too fast. If it's too windy and you're using an aerosol paint, your paint may dissipate before it reaches the surface. Either wait for the wind to die down or use cardboard to build a spray tunnel. Humidity can affect the paint's dry time, which leaves more time for surface imperfections to take place on your finish. In general, 21ºC and about 50% humidity are ideal conditions for painting.
12 Any last tips?
Remember to protect other surfaces if working outside by using masking tape and drop cloths. Most importantly, regardless of your project, remember to always read product labels thoroughly and follow directions.
Marble Contact Paper in Marmi Grey, Design Your Wall.
These faux marble options are just as elegant as the real deal.
Few materials strike a chord with us in the same way that marble does. The sought-after stone, with its subtle sheen and veined markings, is quick to catch the eye and lends a luxe look to a space without being over the top. The downside, of course, is its price point. Here are 5 marble-like options that will achieve the same sophisticated, formal look for a fraction of the cost.
Looking for a faux marble tile that can handle heavy foot traffic? Consider peel-and-stick vinyl floor tiles. In addition to their resilient nature, the tiles can be installed over most existing flooring. In other words, they make for a perfect weekend DIY project that won’t end in defeat. TrafficMaster Premium Vinyl Tile in Carrara Marble, Home Depot, starting at $0.89/sq. ft.
If you love the marbled look, you’ll want to customize all of your furniture with this stylish contact paper. The affordable material has a peel-away backing that can stick to almost any surface, from the top of a coffee table to the inside of kitchen drawers. Keep in mind that the paper doesn’t react well to water, so avoid using it in the bathroom or near the kitchen sink. Marble Contact Paper in Marmi Grey, Design Your Wall, $59.99 per roll.
Elevate your living space with ceramic wall tiles that mimic the look of marble like this elegant option from Ciot. Though similar in appearance, ceramic is far more delicate than marble and is therefore more susceptible to chips and cracks. The solution: Be strategic with placement, avoiding high-traffic areas in favour of bathroom walls or backsplashes. Marvel Wall Tile in Calacatta Extra, Ciot, see store for pricing.
Porcelain is another classic material that boasts marble's polished aesthetic without the hefty price tag. The tile is more resilient than ceramic, which makes it perfect for flooring as well as bathroom walls and kitchen backsplashes. Let's just say marble-inspired porcelain has the ability to make any space sparkle. Glazed Porcelain Tiles in White, Olympia Tile + Stone, see store for pricing.
If you’re not yet familiar with Laminam, allow us to be the first to introduce you. The innovative material is touted as being the world’s first porcelain tile that's offered in 3 metre by 1 metre panels and is thinner than standard porcelain tiling. This means that in addition to covering existing walls and floors, Laminam can take on an array of delicate surfaces (think fireplace surrounds, kitchen countertops and outdoor areas). I Naturali Laminam in Bianco Statuario, Stone Tile, see store for pricing.